EasyManuals Logo

Hoover WindTunnel User Manual

Hoover WindTunnel
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
Filter bag
When to replace
Check filter bag from time to time. It is
recommended that you change the filter
bag when dirt reaches the dotted line. If
more dirt than this accumulates, your
cleaner will not operate effectively.
NOTE: All new carpet has loose fibers
which can fill the bag quickly while
vacuuming. This type of debris does not
activate the "Check Bag" indicator
available on some models.
So, if you are using the cleaner on new
carpet, be sure to change the filter bag
often, even if you have a "Check Bag"
indicator and it does not show red.
CAUTION: Very fine materials, such as
face powder, cornstarch, fireplace
ashes or fireplace soot, may seal the
filter bag and may cause it to burst
even though it is only partially full of
dirt. When cleaner is used to remove
material of this nature, change filter
bag often.
Where to buy
Filter bags may be purchased from your
Authorized Hoover Dealer (Depot),
Leading Retailers, Hoover Factory
Service Centers or through The Hoover
Company on-line at www.hoover.com
3-1
Changing filter bag
Disconnect cleaner from electrical
outlet.
A
B
Removing and installing filter
bag
Grasp filter bag collar (A) and pull collar
from tube (B).
Note: Do not clean out old filter bag and
reuse. Discard used filter bag.
Hold new filter bag as shown. Align
opening in filter bag with (B).
Push (A) firmly onto (B).
3-2
Removing bag door
To change filter bag, push down at top of
bag door and pull door forward.
Remove door.
It is imperative that you use only genuine
HOOVER filter bags made by The Hoover
What to buy
To assure cleaning effectiveness, use
only Genuine HOOVER® Allergen
Filtration Type Y disposable filter bags.
H
Attach wand and tools
Attach tool, wand or crevice wand* to the
hose (H) by pushing it firmly into hose.
Attach second wand, tool or crevice
wand* to the wand in the same manner.
Twist wand or tool slightly to tighten or
loosen the connection.
For models with crevice wand, the
dusting brush (I) can be attached to the
crevice wand.*
*included with some models
Check bag indicator
(some models only)
The indicator (J), will begin to show red
as filter bag fills with dirt.
There are three conditions that will cause
the indicator to become completely red:
1. The bag is full; change the bag.
2. Very fine materials have been picked
up, clogging the bag pores; change the
bag.
3. There is a blockage in the nozzle,
hose, tools or at the bag opening; remove
the blockage (see “Clearing blockages”
section).

Other manuals for Hoover WindTunnel

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hoover WindTunnel and is the answer not in the manual?

Hoover WindTunnel Specifications

General IconGeneral
TypeUpright
Bagged/BaglessBagless
Filter TypeHEPA
Power12 amps
FeaturesWindTunnel Technology
Dust Capacity1.5 liters
Height44 inches
Width13 inches
ColorBlue

Related product manuals