What causes flow rate 1 errors on horiba APMA-370 Measuring Instruments?
A flow rate 1 error (optional) on Horiba Measuring Instruments can be due to a leak on the measured gas line or the calibration gas line. Check to see whether the measured gas line and the calibration gas line are connected properly. If either or both of these gas lines are disconnected, connect them properly.
What does TELE Telemeter failure mean for horiba APMA-370?
TELE: Telemeter failure means that no closed contact signal is received from the telemeter. Check the telemeter and the wiring.
General| Measurement Method | Chemiluminescence |
|---|---|
| Linearity | ±1% of full scale |
| Resolution | 0.1 ppm |
| Sample Gas Flow Rate | 1 L/min |
| Power Supply | AC100V-240V, 50/60 Hz |
| Dimensions | 400 x 300 x 200 mm |
| Measurement Principle | Chemiluminescence |
| Sampling Flow Rate | 1 L/min |
| Output | Digital output (RS-232C) |
| Dimensions (Alt) | 400 x 300 x 200 mm |
| Weight (Alt) | 10 kg |
To Next Page