EN
10
Air Tractor 1.5m
SAFE Select Switch Designation
Once SAFE Select is enabled, you can choose to fly in SAFE mode full-time, or
assign a switch. Any switch on any channel between 5 and 9 can be used on
your transmitter.
If the aircraft is bound with SAFE Select disabled, the aircraft will be in AS3X
mode exclusively.
CAUTION: Keep all body parts well clear of the propeller and keep the
aircraft securely restrained in case of accidental throttle activation.
IMPORTANT: To be able to assign a switch, first verify:
• The aircraft was bound with SAFE Select enabled.
• Your choice for the SAFE Select switch is assigned to a channel between
5 and 9 (Gear, Aux1-4), and travel is set at 100% in each direction.
• The aileron, elevator, rudder and throttle direction are set to normal,
not reverse.
• The aileron, elevator, rudder and throttle are set to 100% travel. If dual
rates are in use, the switches need to be in the 100% position.
See your transmitter manual for more information about assigning a switch to a channel.
Assigning a Switch
1. Power on the transmitter.
2. Power on the aircraft.
3. Hold both transmitter sticks to the inside bottom corners, and toggle the
desired switch 5 times quickly (1 toggle = full up and down).
4. The control surfaces of the aircraft will move, indicating the switch has
been selected.
Repeat the process to assign a different switch or to deactivate the current switch.
Mode 1 and 2 transmitters
X 5
100%
100%
Assigned Switch
Monitor
THR
-100
AIL
100
ELE
-100
RUD
-100
GER
-100
AX1
-100
AX2
+/-100
AX3
-100
AX4
-100
This example of the channel monitor shows the stick positions for assigning a
switch, the switch selection on Aux2, and +/- 100% travel on the switch.
Measure the elevator travel on the elevator trim tabs
SAFE Select Switch Assignment Stick Positions
TIP: Use the channel monitor to verify channel movement.
Program your transmitter to set the rates and control throws based on your
experience level. These values have been tested and are a good starting point to
achieve successful first flight.
After flying, you may choose to adjust the values for the desired control response.
Dual Rates and Control Throws
Low Rate High Rate
Aileron
14mm 20mm
Elevator
7mm 10mm
Rudder
22mm 22mm
Flap Travel
Half q = 10mm
Full q = 20mm
To Next Page
Loading...
Need help?
General
