TR10A108-B RE / 02.2013
41
Dismantling and Disposal13
NOTE:
When disassembling, observe the applicable regulations
regarding occupational safety.
Have a specialist dismantle the garage door operator in the
reverse order of these instructions and dispose of it properly.
Warranty Conditions14
Warranty period
In addition to the statutory warranty provided by the dealer in
the sales contract, we grant the following warranty for parts
from the date of purchase:
5 years on operator technology, motor and motor controlō
2 years on radio equipment, accessories and special ō
systems
Claims made under the warranty do not extend the warranty
period. For replacement parts and repairs the warranty period
is six months or at least the remainder of the warranty period.
Prerequisites
The warranty claim only applies in the country where the
equipment was purchased. The product must have been
purchased through our authorised distribution channels.
A claim under this warranty exists only for damage to the
object of the contract itself.
Services
For the duration of the warranty we shall eliminate any product
defects that are proven to be attributable to a material or
manufacturing fault. We pledge to replace free of charge and
at our discretion the defective goods with non-defective
goods, to carry out repairs, or to grant a price reduction.
Replaced parts become our property.
Reimbursement of expenditure for dismantling and fitting,
testing of parts as well as demands for lost profits and
compensation for damages are excluded from the warranty.
Damage caused by the following is also excluded:
Improper fitting and connectionō
Improper initial start-up and operation ō
External factors such as fire, water, abnormal ō
environmental conditions
Mechanical damage caused by accidents, falls, impactsō
Negligent or intentional destruction ō
Normal wear or deficient maintenanceō
Repairs conducted by unqualified persons ō
Use of non-original partsō
Removal or defacing of the data labelō
Excerpt from the Declaration of 15
Incorporation
(as defined in EC Machinery Directive 2006/42/EC for
incorporation of partly completed machinery according to
annex II, part 1 B).
The product described on the reverse side has been
developed, constructed and produced in accordance with the
following directives:
EC Machinery Directive 2006/42 ECō
EC Construction Products Directive 89/106/EECō
EC Directive Low-Voltage 2006/95/ECō
EC Electromagnetic Compatibility Directive 2004/108/ECō
Applied and consulted standards and specifications:
EN ISO 13849-1, PL “c”, Cat. 2 ō
Safety of machinery – Safety-related parts of control
systems – Part 1: General principles
EN 60335-1/2, when applicable ō
Safety of electrical appliances / Operators for doors
EN 61000-6-3 ō
Electromagnetic Compatibility – Electromagnetic radiation
EN 61000-6-2 ō
Electromagnetic Compatibility – Interference immunity
Partly completed machinery as defined in the EC Directive
2006/42/EC is only intended to be incorporated into or
assembled with other machinery or other partly completed
machinery or equipment, thereby forming machinery to which
this Directive applies.
This is why this product must only be put into operation after it
has been determined that the entire machine / system in which
it will be installed corresponds with the guidelines of the EC
Directive mentioned above.
Any modification made to this product without our express
permission and approval shall render this declaration null and
void.
ENGLISH
To Next Page
Loading...