EasyManua.ls Logo

Hotpoint UE47X - If something goes wrong...

Hotpoint UE47X
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
30
GB
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
If something
goes wrong...
Before calling a Service Engineer, please check through the following lists.
THERE MAY BE NOTHING WRONG.
Prblm h:
Nthingwor:s.
(a) Check
If you find :-
Display is blank.
Thenitisli:elythatthereisnoelectricitysupplytoyouroven.
Check:
(i) That the main cooker wall switch is turned on.
(ii) Check other appliances to see if you have a power cut.
(iii) Check the main circuit breaker for the property.
TimerDisplay@D.DDAUTO@
The power supply to your oven has possibly been interrupted, but has now come
back on again. Reset the timer to the correct day and "Manual" operation using the
instructions given in the timer section of the book.
Main&TopOvensdonot
wor:H
buttheGrillwor:s.
Check the following to ensure that the timer is in Manual Mode: Check that the Auto
Symbol is not lit up and is not flashing. See timer section for instructions on how to
return timer to "Manual".
TopOvensandGrilldonot
wor:HbuttheMainOven
wor:s.
Operating the cooker under the following conditions may cause a safety device to
operate.
(a) Grilling with the door closed - always grill with the door open to the correct
position - see grilling
(b) Grilling for an excessively long period at maximum setting - see grilling guide.
(c) Grilling with inadequate ventilation in the cabinet - see installation instructions.
Grill:eepsturningonandoff
When the "Grill" control (A) is operating at less than MAX, the grill will cycle on and
off, this is normal and is not a fault.
Cannotsetan@AutoCoo:@
programme
Remember: "Cook Period" is the actual length of time for which, the timer will switch
the oven(s) on as part of an "Auto Cooking" programme.
Draughtfrombeneathcontrol
panel.
A gentle flow of air will be blown from beneath the control panel when the appliance
is used. If the appliance is still warm, this cooling fan may run on, or restart itself after
all of the controls have been turned off. The fan will stop once the appliance has
been cooled. This is normal and not a fault.
TimerbuIIer/bleeperoperates
continually
Press the minute minder button to silence the Buzzer/Bleeper.
If you have been through the above list and there is still a problem, contact Service
Disposal of your product
To minimise the risk of injury to children please dispose of your product carefully and safely. Remove all doors
and lids. Remove the mains cable (where fitted) by cutting off flush with the appliance and always ensure that
no plug is left in a condition where it could be connected to the electricity supply.
To help the environment, Local Authority instructions should be followed for the disposal of your product.
Disposal of old electrical appliances
The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that old
household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old
appliances must be collected separately in order to optimise the recovery and recycling of the materials they
contain and reduce the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you dispose of
the appliance it must be separately collected.
Consumers should contact their local authority or retailer for information concerning the correct disposal of their
old appliance.

Related product manuals