EasyManuals Logo

HotSpring HOT SPOT Relay Instructions

HotSpring HOT SPOT Relay
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
Page 7 Pre-Delivery Instructions
STRIDE
®
(Model STD)
Dimensions
NOTE: All dimensions are approximate; measure your spa before making critical design or
pathway decisions. Configuration and location may change without notice.
NOTE: WATKINS WELLNESS recommends that the STRIDE be installed on a minimum 4” (10.2 cm) thick reinforced
concrete pad or structurally sound deck able to support the “dead weight” found in the spa specification chart.
IMPORTANT: THE STRIDE MUST NOT BE SHIMMED IN ANY MANNER.
FRONT
VIEW
BOTTOM
VIEW
DOOR SIDE
ELECTRICAL
CUTOUT
ELECTRICAL
CUTOUT
ELECTRICAL CUTOUT (CENTER)
DRAIN
AIR VENTS BELOW DOOR
DO NOT BLOCK
11.5" (29 cm)
2.5" (6.4 cm)
22.5"
(57.2 cm)
29"
(73.7 cm)
OVERALL
84.5" (214.5 cm)
PEDESTAL
79" (201.1 cm)
ELECTRICAL
CUTOUT
ELECTRICAL
CUTOUT
1.70" (4.3 cm)
1.70" (4.3 cm)
OVERALL
65.5"
(166.3 cm)
PEDESTAL
61" (154.8 cm)
RADIUS
5.5" (13.8 cm)
DOOR PANEL
67.5" (171.5 cm)

Other manuals for HotSpring HOT SPOT Relay

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HotSpring HOT SPOT Relay and is the answer not in the manual?

HotSpring HOT SPOT Relay Specifications

General IconGeneral
BrandHotSpring
ModelHOT SPOT Relay
CategoryHot Tub
LanguageEnglish

Related product manuals