What to do if my HotSpring Hot Tub water is causing eye irritation?
If you're experiencing eye irritation from your HotSpring Hot Tub water, it could be due to low pH or low sanitizer levels. Adjust the pH, and shock the spa with sanitizer and maintain the sanitizer level.
How to fix organic buildup around my HotSpring Jetsetter JJ Hot Tub?
Organic buildup or a scum ring around your HotSpring Hot Tub is caused by a build-up of oils and dirt. Wipe off the scum with a clean rag. If it's severe, drain the spa, use a spa surface and tile cleaner to remove the scum, and refill the spa.
What to do if my HotSpring Jetsetter JJ water is causing skin irritation or rash?
If you're experiencing skin irritation or a rash from your HotSpring Hot Tub water, it could be due to unsanitary water or a free chlorine level above 5 ppm. Shock the spa with sanitizer and maintain the sanitizer level. Also, allow the free chlorine level to drop below 5 ppm before using the spa.
What to do if my Moto-Massage® jet is inoperative in my HotSpring Hot Tub?
If the Moto-Massage® jet in your HotSpring Hot Tub is inoperative or erratic, it could be due to closed Comfort Control valves or clogged filters. To resolve this, open the Comfort Control levers and clean the filters.
General| Seating Capacity | 3 |
|---|---|
| Jets | 14 |
| Heater | 1.5 kW |
| Pump | 1.5 HP |
| Voltage | 240V |
| Insulation | Full Foam |
| Shell Material | Acrylic |
| Cabinet Material | Synthetic wood |
| Warranty | 5 years |
Essential safety guidelines for spa operation and user protection.
Precautions to prevent child drowning and ensure supervision.
Safety measures to prevent electrical shock hazards.
Detailed instructions for electrical safety and grounding.
Guidelines to minimize injury risks, including water temperature limits.
Warnings about potential injuries from spa use.
How to prevent skin burns from hot spa water.
Dangers of prolonged immersion in hot water.
Steps for initial spa setup and filling.
Critical warnings before operating the spa after filling.
Procedure for draining and filling the spa correctly.
Steps for powering up the spa after filling.
Adjusting water chemistry parameters like TA, CH, and pH.
Procedure for adding chlorine for initial sanitization.
How to set and lock the spa water temperature.
Final check of water chemistry parameters.
Recommended target and range for water parameters.
Guidelines for safe handling and use of spa chemicals.
Step-by-step guide for adding chemicals to the spa.
Maintaining primary water parameters for balance and protection.
Details on Calcium Hardness, Total Alkalinity, and pH.
Importance of maintaining sanitizer levels for safety.
Weekly or monthly shock treatment procedures.
How to activate and deactivate temperature lock.
How to activate and deactivate the spa lock feature.
Step-by-step guide for draining and refilling the spa.
Wiring diagram for specific 230V models.
Wiring connection details for specific models.
Explanation and testing of the 115V GFCI.
Wiring diagram for Prodigy/Jetsetter 230V models.
Requirements for 115V operation.
Warning against using extension cords for spa connection.
Steps for converting a spa from 115V to 230V.
Troubleshooting GFCI and high limit thermostat issues.
Troubleshooting the circulation pump and its thermal cut-off.
Common operational problems and their solutions.
Troubleshooting common spa water quality issues.
To Next Page