NOTE: It may be necessary to allow for addional over-head clearance if the spa (with cart) will be pushed up or
down an incline or moved up or down a short ight of stairs.
Use the informaon below to determine the requirements for access to you desired locaon.
It may be necessary to remove a gate, part of a fence, or other moveable obstrucons to roll the spa to its installaon
site. About 10% of the me, a crane is the only way to install the spa by liing it to its nal desnaon.
If the spa must be taken o the cart to go over a wall (either because the entry area is too narrow, the eaves are too
low, the corner is too ght, or the stairway is too steep), a crane will be required. Don’t be alarmed!
The crane has a truck-mounted boom which can t right in your driveway. Crane operators are licensed and insured.
For a charge, the crane operator will li your spa over walls, buildings, or any other obstrucons and place it as close
to the installaon site as possible. The Hot Spring spa delivery personnel will supervise the crane delivery and
complete spa installaon.
NOTE: if your spa delivery requires the use of a crane, you may be required to pay for the services at the compleon
of the delivery.
DELIVERY ACCESS
First, note the dimensions of your spa below. The dimensions are the measurements of the spa in the vercal
posion, laid on its side as shown in the drawing below.
Next, contact your dealer to nd the height and width added by the delivery cart which the dealer will use to deliver
your new spa. Use the height of the cart plus the dimension shown as ‘H’ to determine the vercal clearance
required to pass the spa and cart. Use the width of the chart, or dimension ‘W’, whichever is greater, to determine
the maximum width of clearance necessary. Use the length dimension ‘L’ when making any sharp turns to determine
the minimum clearance required.
To Next Page
Loading...
