Hotsy 965SS User Manual

40 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

9.807-621.0

SERIAL NUMBER:

DATE PURCHASED:

FOR SALES AND SERVICE, PLEASE CONTACT:

®

c

L

I

S

T

E

D

®

OPERATING INSTRUCTIONS AND PARTS MANUAL

Thank you for purchasing a Hotsy Pressure Washer. This manual covers the operation and mainte-

nance of your pressure washer. All information in this manual is based on the latest product informa-

tion available at the time of printing. Hotsy, Inc. reserves the right to make changes at any time with-

out incurring any obligation.

Read instructions carefully before attempting to assemble, install, operate or service this pressure

washer. Failure to comply with instructions could result in personal injury and/or property damage!

MODELS 965SS, 1065SS,

1065SSE, 1075SSE

Table of Contents

Other manuals for Hotsy 965SS

Operating And Parts Manual19 pages

Questions and Answers:

K
Kent ColeSep 5, 2025
What to do if my Hotsy Pressure Washer runs but won’t spray?
- T
  Taylor EstradaSep 5, 2025
  If your Hotsy Pressure Washer runs but won't spray, the trigger of the trigger gun might be released, so squeeze it. The water supply might not be turned on, so open the water supply valve. The pressure nozzle could be clogged, so clean the pressure nozzle opening. If water spray doesn’t show within 10-15 seconds, discontinue running the machine and troubleshoot, as damage to the pump will occur if allowed to run.
T
Tracy ReevesAug 25, 2025
Why Hotsy 965SS Pressure Washer gas engine will not run?
- R
  Robert BurgessAug 25, 2025
  The gas engine of your Hotsy Pressure Washer might not be running due to several reasons: it could be out of gas (replenish the supply, using only recommended fuels), the fuel valve might be closed (open the valve), the spark plug wire might be loose (reconnect it), the choke or throttle might be set incorrectly (refer to the Operation section for correct settings), the engine ON/OFF switch might be in the OFF position (place it in the ON position), or the engine oil level might be low (replenish the supply).
T
tcervantesAug 25, 2025
What to do if Hotsy Pressure Washer runs but won’t spray?
- E
  Ebony HornAug 26, 2025
  If your Hotsy Pressure Washer is running but not spraying, it could be due to the trigger of the gun being released (squeeze the trigger), the water supply not being turned on (open the water supply valve), or a clogged pressure nozzle (clean the pressure nozzle opening). If water spray doesn’t show within 10-15 seconds, discontinue running the machine and troubleshoot, as damage to the pump will occur if allowed to run.
A
Angelica HarperAug 27, 2025
What to do if my Hotsy 965SS Pressure Washer runs, but won't spray?
- D
  Dorothy FreemanAug 27, 2025
  If your Hotsy Pressure Washer runs but doesn't spray, start by checking the trigger gun to ensure the trigger is squeezed. Then, make sure the water supply is turned on fully. A clogged pressure nozzle can also cause this issue, so clean the nozzle opening. If water spray doesn’t appear within 10-15 seconds, discontinue running the machine to prevent pump damage.
D
Denise CampbellAug 27, 2025
How to fix low spray pressure on my Hotsy Pressure Washer?
- B
  Brian HarrisAug 27, 2025
  If you're experiencing low spray pressure at the nozzle of your Hotsy Pressure Washer, check the following: First, ensure you have an adequate water supply by fully opening the faucet and inspecting the hose for kinks or damage. Use a 3/4 inch minimum hose size. Also, check the inlet screen for any debris. The pressure nozzle may be partially clogged or damaged, so clean or replace it as necessary. If you're using detergent, make sure air isn't being drawn through the detergent inlet line by refilling the detergent container and ensuring the pick-up screen is fully immersed. Finally, verify that the detergent injector valve is correctly set.
J
Justin JohnsonSep 14, 2025
Why is my Hotsy 965SS doing a poor cleaning job?
- A
  Albert LewisSep 14, 2025
  If your Hotsy Pressure Washer is not cleaning well, it could be due to improper detergent concentration or mixing (mix detergent per manufacturer’s instructions, ensuring powdered detergents are fully dissolved), using the wrong detergent for the application (select an appropriate detergent), or rinsing with hot water (a final rinse with cold water will reduce water spotting).
J
Jeffrey Moody DVMSep 12, 2025
What causes the water temperature to be too hot on my Hotsy 965SS Pressure Washer?
- D
  Devin EvansSep 12, 2025
  If the water temperature from your Hotsy Pressure Washer is too hot, consider these factors: Lower the incoming water temperature if it's already warm. Check and lower the fuel pump pressure if it's too high. If the fuel pump is defective, replace it. Ensure the detergent line isn't sucking air by tightening all clamps and checking for holes. Replace the high limit switch if it's defective. Verify you're using the correct fuel nozzle size. Finally, ensure sufficient water is being supplied and check the nozzle for obstructions and proper sizing.
J
Jennifer AndersonSep 13, 2025
Why does my Hotsy 965SS Pressure Washer have an uneven spray pattern?
- J
  Joseph DavisSep 13, 2025
  An uneven spray pattern from your Hotsy Pressure Washer is likely due to a partially clogged or damaged pressure nozzle. Try cleaning or replacing it.
J
Jeffrey BentonSep 4, 2025
How to fix low spray pressure at pressure nozzle of Hotsy 965SS Pressure Washer?
- L
  lanerichardSep 4, 2025
  If you're experiencing low spray pressure at the pressure nozzle of your Hotsy Pressure Washer, here's what to check: * Ensure you have an adequate water supply by fully opening the faucet, checking for kinks or damage in the hose, using at least a 3/4 inch hose, and checking the inlet screen for debris. * Clean or replace the pressure nozzle if it's partially clogged or damaged. * Refill the detergent container and ensure the pick-up screen is fully immersed if air is being drawn through the detergent inlet line.
H
Heather JordanSep 2, 2025
What to do if Hotsy 965SS has poor or no detergent flow?
- A
  Amy TaylorSep 2, 2025
  If your Hotsy Pressure Washer has poor or no detergent flow, the issue could be due to an inadequate detergent supply (refill the container, ensure the pick-up screen is immersed, and open the detergent valve), a clogged detergent screen or hose (clean it, always starting with a clean container), a detergent injector valve not set correctly, or a clogged detergent injector check valve (clean the check valve at the detergent injector inlet).

Hotsy 965SS Specifications

General

Brand	Hotsy
Model	965SS
Category	Pressure Washer
Language	English

Related product manuals

Preview: Hotsy 965B Series

Hotsy 965B Series

Hotsy 992SS-208

Hotsy 952SS-208

Preview: Hotsy 790SS

Preview: Hotsy 1075BE

Preview: Hotsy 1800 Series

Hotsy 1800 Series