EasyManua.ls Logo

Hotsy 965B Series - User Manual

Hotsy 965B Series
26 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
8.931-236.0 - BD 03/01/23
965B, 1075BE, 1080BE Series
Hot Water - Gas Engine
Operator’s Manual
Pressure Washer
CHAUD!
MODELS: 965B
1.110-565.0
1075BE
1.110-566.0
1075BE CAL
1.110-082.0
1080BE
1.110-567.0
1080BEK
1.110-094.0
For the Hotsy Dealer nearest you,
consult our web page at
www.hotsy.com

Table of Contents

Questions and Answers

  • N
    Natalie MathewsAug 7, 2025
    What to do if my Hotsy Pressure Washer burner will not ignite when the trigger gun is open?
    • N
      Nicole HumphreyAug 7, 2025
      If the burner on your Hotsy Pressure Washer won't ignite when the trigger gun is open, it might be due to several reasons. First, ensure there is enough fuel and replenish if needed. If fuel isn't the issue, the adjustable thermostat might be set too low, so raise the temperature setting. A defective pressure switch could also be the cause, requiring repair or replacement. Finally, check the AC generator.
  • J
    Jordan ThomasAug 11, 2025
    What to do if my Hotsy 965B engine will not run?
    • R
      Regina CarsonAug 11, 2025
      If your Hotsy Pressure Washer engine isn't starting, there could be a few reasons. First, check if you have enough fuel and replenish if needed. If fuel isn't the issue, the battery might be low, so try charging it. Also, inspect the battery cable connections for any poor connections; clean the terminals and check the cables.
  • A
    Angela ComptonAug 15, 2025
    Why is my Hotsy 965B smoking or has an obnoxious odor?
    • X
      xgutierrezAug 15, 2025
      If your Hotsy Pressure Washer's burner is smoking or emitting an unpleasant odor, it could be due to air bands needing adjustment; readjust them. Another potential cause is using improper fuel. Ensure you are using kerosene, #1 Grade Home Heating Oil, or #1 or #2 Diesel Fuel, and avoid using gasoline.
  • T
    Tanya TaylorAug 20, 2025
    How to resolve low pressure from Hotsy Pressure Washer spray nozzle?
    • R
      ramirezmelissaAug 20, 2025
      If you're experiencing low pressure from your Hotsy Pressure Washer's spray nozzle, consider these potential causes: The inlet might be clogged, so try cleaning it. The spray nozzle could be worn or the incorrect size, in which case, replace it. Ensure you have an adequate water supply and increase it if necessary. The pump might be sucking air, so fill the detergent container and check for loose hose clamps or fittings.
  • J
    Jennifer RodriguezAug 25, 2025
    Why is there no water coming from my Hotsy 965B Pressure Washer nozzle?
    • J
      Jennifer MillerAug 25, 2025
      If you're not getting any water from your Hotsy Pressure Washer nozzle, it could be due to several reasons. The pressure nozzle might be clogged, so try cleaning it. Alternatively, the inlet water screen could be obstructed, requiring cleaning. Lastly, the pump might be sucking air; in this case, fill the detergent container and inspect hose clamps and fittings for any looseness.
  • B
    Bianca MartinAug 28, 2025
    Why is my Hotsy Pressure Washer unloader valve cycling when the trigger gun is open or closed?
    • O
      ocunninghamAug 28, 2025
      If the unloader valve on your Hotsy Pressure Washer cycles when the trigger gun is open or closed, it could be due to air in the system. Try opening and closing the trigger gun several times to resolve this. Another possible cause is a defective unloader valve, which would need repair or replacement. Lastly, check for water leaks between the unloader valve and trigger gun, inspecting fittings, the hose, and the trigger gun itself for leaks; repair or replace as necessary.
  • S
    Suzanne ChenSep 2, 2025
    Why is there poor or no detergent flow in my Hotsy 965B Pressure Washer?
    • C
      Colin HamiltonSep 2, 2025
      If you're experiencing poor or no detergent flow in your Hotsy Pressure Washer, consider these potential causes: The detergent level might be low, so replenish the supply. The detergent screen could be clogged, requiring cleaning. Check that the handle or knob isn't slipping on the shaft of the detergent metering valve. Also, the pressure nozzle might be clogged, so try cleaning it.

Hotsy 965B Series Specifications

General IconGeneral
Model965B Series
CategoryPressure Washer
Pressure3000 PSI
HeaterYes
Nozzle IncludedYes
TypeHot Water
PumpAR Triplex Plunger Pump
Hose Length50 ft

Related product manuals