16
Operations
CAUTION - Never use:
• Bleach, chlorine products and other
corrosive chemicals
• Liquids containing solvents (i.e., paint thinner,
gasoline, oils)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
ATTENTION: Ne jamais utiliser :
• Insecticides, pesticides ou herbicides
• Eau de Javel, produits à base de chlore et
autres produits chimiques corrosifs
• Liquides contenant des solvants (c.-à-d. diluant
à peinture, essence, huiles, etc.)
• Produits à base de tripolyphosphate de sodium
• Ammoniac ou produits à base d'acide
These chemicals will harm the machine and will
damage the surface being cleaned.
Rinsing
It will take a few seconds for the detergent to clear.
Apply safety latch to spray gun and close detergent
valve. Select and install the desired high pressure
nozzle.
Shutdown Instructions & Storage
1. If detergents were used, draw clear water through
the system to purge detergent.
2. If burner was used, turn OFF burner switch, and
allow pump to run cold water through coil.
3. Move throttle control to idle position.
4. Turn key on engine counterclockwise (CCW) to
OFF position.
5. Turn OFF fuel shut-off valve.
6. Turn OFF water supply.
7. Squeeze trigger gun open to relieve system
pressure.
Storage
DANGER: Do not store flammable liquids (gasoline,
solvents, etc.) near pressure washer, or in non-
ventilated areas.
DANGER:
Ne pas entreposer de liquides
inflammables (essence, mazout, pétrole, solvants,
etc.) à proximité de la laveuse à pression ou dans des
endroits non ventilés.
Protect from freezing by storing in a heated area, or by
flushing the system with antifreeze. To flush the
system, fill the float tank with antifreeze and remove
spray nozzle from wand. Start the machine and allow it
to run until antifreeze flows from the end of the wand.
Place end of wand into float tank and circulate the anti-
freeze through system for several minutes. Open and
close the trigger gun several times to circulate anti-
freeze through the unloader valve. Place detergent line
into the float tank. Open the detergent metering valve to
draw antifreeze into the detergent system.
If the pressure washer is not to be used for a consider-
able length of time, it is recommended to flush the
system with antifreeze for rust protection.
Hotsy Gas Belt Drive Series Operator’s Manual 8.931-236.0 - BD
To Next Page
Loading...
Need help?
General
