• While sustaining a high discharge current during use (such as
driving up a steep slope for a long period of time), the Blast will have
alerting, stop using the Blast within 15 seconds.
WARNING
When the Blast turns off during a Safety
Alert, all operation systems will halt. Do
not continue attempting to ride the
Blast when the system initiates a stop.
Turn your Blast off and then turn the
board back on. And check calibration.
CHARGING YOUR BLAST
CHARGING THE BLAST
Ensure that the charging port is clean and dry.
• Make sure that there is no dust, debris or dirt inside the port.
Plug the charger into a grounded wall outlet. The charging
indicator light ON THE CHARGER will be green.
• Connect the cable with the power supply (l OOV 240V; 50/60 Hz).
Align and connect the 3-pin charging cable into the charging
port of the Blast. DO NOT FORCE THE CHARGER INTO THE CHARGE
PORT, AS THIS MAY CAUSE THE PRONGS TO BREAK OFF OR
PERMANENT DAMAGE TO THE CHARGE PORT.
• Once attached to the board, the charging indicator light ON THE
CHARGER should change to RED, indicating that your device is now
being charged.
• When the RED indicator light on your charger turns to GREEN, then
your Blast is fully charged.
A full charge may take up to 5 hours. While charging, you will see
a yellow flashing light on the scooter, which also indicates charging.
Do not charge for more than 7.5 hoors.
'After fully charging your Blast, unplug the charger from your Blast
and from the power outlet.
To Next Page
Loading...
