Please visit
www.hover-1.eu/troubleshoot
to request missing
or defective parts
INSTALLING YOUR HOVER-1 KART
If you have questions or concerns about any of these steps, please feel free to contact our Customer Service
Team at www.hover-1.eu/troubleshoot. Someone will be in touch to walk you through these steps.
Carefully follow the steps shown on the following pages for installing the Hover-1 Kart onto your electric
scooter. Read the remainder of this manual before riding your Hover-1 Kart.
Your Hover-1 Kart should be completely assembled prior to installing it onto your electric scooter. Please refer
to the “Assembling your Hover-1 Kart” section for assembling procedures.
1. Place the pedal mounts onto the foot pedals of your self-balancing scooter with the front wheel facing
forward. Ensure the pedal mounts are centered on the foot pedals of your scooter as much as possible.
For instructions on how to calibrate your Hover-1,
please visit www.hover-1.eu/troubleshoot
Hoverboard must be calibrated and turned OFF prior to installing kart.
Please follow the manufacturer's instructions for calibrating
your hoverboard, as they may vary by brand and model.
9
To Next Page
Loading...
