Hover-1 MY FIRST E-BIKE - Page 17

• Ensure that the charging port is clean and dry.
• Make sure that there is no dust, debris, or dirt inside the port.
• Plug the charger into a grounded wall outlet. The charging indicator light
on the charger will light up red if your My First EBike is not fully charged.
• Connect the cable with the power supply (100V240V; 50 Hz/60 Hz).
• Align and connect the charging cable into the charging port of the My
First EBike, which is located under the frame. DO NOT FORCE OR BEND
THE CHARGING CABLE INTO THE CHARGING PORT, AS IT MAY CAUSE
THE PRONGS TO BEND OR BREAK.
• Once attached to the EBike, the charging indicator light on the charger
should turn red, indicating that your device is now being charged.
• When the red light on your charger changes to green, then your My First
EBike is fully charged. A full charge may take up to 4 hours. Do not
overcharge the battery.
•After fully charging your My First EBike, unplug the charger from your
My First EBike and from the power outlet.
CHARGING YOUR MY FIRST E-BIKE
15