EasyManua.ls Logo

Hover-1 RANGER - Safety Alerts and Error Handling

Hover-1 RANGER
27 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SAFETY ALERTS
While riding your Ranger, if there is a system error or illegal operation
performed the device will prompt the user in a variety of ways.
You will notice the Running Indicator Light will turn RED and you will
hear a beep sound alerting you to take precaution and cease
operation, which may make the device stop suddenly.
The following are common occurrences where you will hear the
Safety Alerts. These notices should not be ignored, but
appropriate action should be taken to correct any illegal
operation, failure or errors.
Unsafe riding surfaces (uneven, too steep, unsafe, etc.)
When you step on the device, if the platform is tilted more than 10
degrees forward or backward.
Battery voltage is too low.
The device is still charging.
Dufng operation, the platform self initiates to tilt due to excess speed.
Overheating, or motor temperature is too high.
The device has been rocking back and forth over 30 seconds.
If the system enters protection mode, the alarm indicator will light
up and the board will vibrate. This typically occUs when the battery
is about to run out of power and stop abruptly.
If the platform is tilted forward or backward more than 10 degrees,
your Ranger will power off and stop suddenly, possibly causing the
rider to lose balance or fall off.
If any or both tires are blocked, the device will stop after 2
seconds.
When the battery level has depleted below protection mode, the
device engine will power off and stop after 15 seconds.
While sustaining a high discharge current during use (such as
18

Related product manuals