38
Chapter 9
D82008204 REV B 1/14/04
Chapter 9
Appendixes
Appendix A:
Programmable Parameters
The controller used on your power chair is programmable for basic functions. It
requires a programmer to make changes. Any changes must be made by a
qualified technician only.
The following chart indicates the standard program values of the factory settings.
Refer to the appropriate section depending on the style of control system on your
chair. Any subsequent change of the programmed values should be recorded and
saved for future reference.
Program Settings
VSI VSI PSL Pilot Commando
Acceleration 20 20 20 20
Deceleration 50 50 50 50
Forward Speed Max 100 100 100 100
Forward Speed Min 10 10 10 10
Turn Speed Max 15 10 18 15
Turn Speed Min 10 10 10 5
Reverse Speed Max 55 55 55 60
Reverse Speed Min 10 10 – 10
Turn Acceleration 30 10 30 10
Turn Deceleration 40 25 40 15
To Next Page
Loading...
