3. Plug the DC power cord from the power module—shipped with the print server—into the power
connector on the rear end of the print server . Plug the power module into a power outlet.
❍ Caution! Do not use the power module shipped
with your print server with any other products!
4. Verify the print server’s LEDs:
❍ The 10 or 100 LED on the rear end of the print server lights green to indicate the
connection speed.
❍ The power/status LED on the top front begins blinking and within 15 seconds is solid
green, to indicate the server passed its self test.
To Next Page
Loading...