HP 2520 Series User Manual

8 autosensing 10/100 ports
2 dual-personality ports; each port can be used as either an RJ-45 10/100/1000 port or as a SFP slot
min=0 \ max=2 SFP Transceivers
1U - Height
See Configuration
Note:1, 2
Configuration Rules:
Note 1 The following Transceivers install into this switch:
HP X121 1G SFP LC SX Transceiver J4858C
HP X121 1G SFP LC LX Transceiver J4859C
HP X111 100M SFP LC FX Transceiver J9054C
HP X112 100M SFP LC BX-D Transceiver J9099B
HP X112 100M SFP LC BX-U Transceiver J9100B
HP X121 1G SFP LC LH Transceiver J4860C
HP X122 1G SFP LC BX-D Transceiver J9142B
HP X122 1G SFP LC BX-U Transceiver J9143A
Note 2 If this switch is factory installed in HP Universal Racks, Then the J9583A orJ9583A#0D1 is required.
EMEA then J9583A is required.
APD, Japan and China then J9583A#0D1 is required.
CLIC Only - Allow the J9583AZ in all regions.
Enter the following menu selections as integrated to the CTO Model X server above if order is factory built.
Transceivers
SFP Transceivers
HP X121 1G SFP LC SX Transceiver J4858C
HP X121 1G SFP LC LX Transceiver J4859C
HP X111 100M SFP LC FX Transceiver J9054C
HP X121 1G SFP LC LH Transceiver J4860C
HP X122 1G SFP LC BX-D Transceiver J9142B
HP X122 1G SFP LC BX-U Transceiver J9143B
HP X112 100M SFP LC BX-D Transceiver J9099B
HP X112 100M SFP LC BX-U Transceiver J9100B
Internal Power Supplies
No Power supplies
Cables
Multi-Mode Cables
QuickSpecs
HP 2520 Switch Series
Configuration
DA - 13525 Worldwide — Version 12 — November 12, 2013 Page 6

HP 2520 Series Specifications

General

Ports	8/24
Layer	Layer 2
Management	SNMP
PoE	Available on some models (2520-8-PoE, 2520-24-PoE)
Jumbo Frame Support	Yes
Model	HP 2520 Series