Need help?Do you have a question about the HP 2520-8 and is the answer not in the manual?
General| Model | HP 2520-8 |
|---|---|
| Ports | 8 |
| Layer | Layer 2 |
| Power over Ethernet (PoE) | No |
| Switching Capacity | 16 Gbps |
| Forwarding Rate | 11.9 Mpps |
| Jumbo Frame Support | Yes |
| Input Voltage | 100-240 VAC |
| Type | Switch |
| MAC Address Table Size | 8192 entries |
| Operating Temperature | 0°C to 45°C (32°F to 113°F) |
| Operating relative humidity | 10 to 90% (non-condensing) |
Outlines the general steps for configuring IPv6 on a VLAN.
Details methods for enabling IPv6 and creating link-local addresses.
Explains automatic configuration of global unicast addresses and default router.
Describes how to enable DHCPv6 for IPv6 address and NTP server assignment.
Covers configuring static link-local and global unicast IPv6 addresses.
Explains the process of detecting duplicate IPv6 addresses.
Details how the switch learns about routers and selects a default router.
Defines preferred and valid lifetimes for IPv6 addresses.
How to view and clear the IPv6 neighbor cache.
Describes outbound Telnet, viewing Telnet activity, and inbound Telnet configuration.
Explains SNMP features, configuration commands, and SNMPv1/v2c/v3 support.
How to copy configuration files without overwriting IPv6 settings.
Configure IP addresses/masks to control switch access.
Provides secure CLI access, file transfer via encrypted transactions.
Secure file transfer alternative to TFTP using SSH.
Controls the rate of ICMPv6 error and informational messages.
Point-to-point test to verify IPv6 communication and path.
Traces the route to a device by displaying hops and reply times.
Configures DNS servers for host name resolution and supports dual-stack.
Configures sending debug and event log messages to external devices.
To Next Page
