Need help?Do you have a question about the HP ProCurve 2520G-PoE Series and is the answer not in the manual?
General| Model | HP ProCurve 2520G-PoE Series |
|---|---|
| PoE Support | Yes |
| Switching Capacity | 56 Gbps |
| Layer | Layer 2 |
| MAC Address Table Size | 16, 000 entries |
| Routing Protocol | Static routing |
| VLANs | Up to 256 |
| Power Supply | Internal power supply |
| Operating Temperature | 32°F to 113°F (0°C to 45°C) |
| Ports | 24 or 48 |
| Jumbo Frame Support | Yes |
| Management | Web-based GUI, Command-line interface (CLI), SNMP |
| Features | VLAN, QoS, Link Aggregation, IGMP Snooping |
| Layer 2 Features | Spanning Tree Protocol (STP), Rapid Spanning Tree Protocol (RSTP), Multiple Spanning Tree Protocol (MSTP) |
| Security Features | Access Control Lists (ACLs), Port Security, IEEE 802.1X network access control |
| Operating Humidity | 15% to 95% non-condensing |
| Forwarding Rate | 41.67 Mpps |
Covers safety precautions, site requirements, and environmental considerations for installation.
Provides detailed instructions for rack, cabinet, wall, and horizontal surface mounting.
Guides on connecting the switch to power and network devices using RJ-45 connectors.
Guides on essential initial configuration: IP address, subnet mask, and manager password.
Explains how to perform basic configuration using the console's setup screen.
Describes remote management using Telnet sessions or a Web browser interface.
Provides initial steps and common issues to check for resolving problems.
Interpreting LED patterns for general switch and PoE troubleshooting and error conditions.
Procedure to revert the switch to its original factory default settings.
Covers essential safety practices, grounding, and servicing guidelines.
To Next Page