HP 2520-8

2-21
IPv6 Management Features
SNMP Management for IPv6
SNMP Management for IPv6
As with SNMP for IPv4, you can manage a switch via SNMP from an IPv6-
based network management station by using an application such as E-PCM or
E-PCM+. For more go to the HP web site at www.hp.com/Networking/support.)
SNMP Features Supported
The same SNMP for IPv4 features are supported over IPv6:
■ access to a switch using SNMP version 1, version 2c, or version 3
■ enhanced security with the configuration of SNMP communities and
SNMPv3 user-specific authentication password and privacy (encryption)
settings
■ SNMP notifications, including:
• SNMP version 1 or SNMP version 2c traps
• SNMPv2c informs
• SNMPv3 notification process, including traps
■ Advanced RMON (Remote Monitoring) management
■ E-PCM or E-PCM+ management applications
■ Flow sampling using sFlow
■ Standard MIBs, such as the Bridge MIB (RFC 1493) and the Ethernet MAU
MIB (RFC 1515)
SNMP Configuration Commands Supported
IPv6 addressing is supported in the following SNMP configuration commands:
For more information on each SNMP configuration procedure, refer to the
“Configuring for Network Management Applications” chapter in the current
Management and Configuration Guide for your switch.
SNMPv1 and V2c
Syntax:. snmp-server host < ipv4-addr | ipv6-addr > < community-name >
[none | all | non-info | critical | debug] [inform [retries < count >]
[timeout < interval >]]