4-13
IPv6 Diagnostic and Troubleshooting
Debug/Syslog for IPv6
For more information, see “Configuring Debug and Event Log Messaging” on
page 4-11.
Logging Command
For more information on how to configure a Syslog server and Debug/Syslog
message reports, refer to the “Troubleshooting” appendix in the Management
and Configuration Guide.
Syntax: [no] logging < syslog-ipv4-addr >
Enables or disables Syslog messaging to the specified IPv4
address. You can configure up to six addresses. If you config-
ure an address when none are already configured, this com-
mand enables destination logging (Syslog) and the Event
debug type. Therefore, at a minimum, the switch begins send-
ing Event Log messages to configured Syslog servers. If other
debug message types are configured, they are also sent to the
Syslog server.
no logging removes all currently configured Syslog logging
destinations from the running configuration.
no logging < syslog-ipv4-address > removes only the specified
Syslog logging destination from the running configuration.
Note: The no logging command does not delete the Syslog server
addresses stored in the startup configuration. To delete Syslog
addresses in the startup configuration, you must enter the
no logging command followed by the write memory command. To
verify the deletion of a Syslog server address, display the
startup configuration by entering the show config command.
To block the messages sent to configured Syslog servers from
the currently configured debug message type, enter the no debug
< debug-type > command.
To disable Syslog logging on the switch without deleting con-
figured server addresses, enter the no debug destination logging
command.
To Next Page
Loading...
Need help?
General
