HP 2530 Quick Setup Guide

Power Cord
Use one of the following:
Switch ModelCountry/Region
HPE 2530-48G-PoE+-2SFP+Switch
1
HPE 2530-24G-2SFP+, HPE
2530-24G-PoE+-2SFP+, and HPE
2530-48G-2SFP+ Switches
8120-83758120-6869Argentina
8121-08578121-0834Australia/New Zealand
8121-11328121-1069Brazil
8120-83898120-6980Chile
8121-10348120-8377China
8120-53368120-6802Continental Europe
8120-53408120-6806Denmark
8120-53418121-0780India
8121-10098121-1035Israel
8120-53428120-6804Japan
8120-53348120-6809Malaysia
8120-53398120-6807Switzerland
8120-53418121-0919South Africa
8120-53368120-6811South Korea
8121-09678121-0964Taiwan
8121-06718121-0673Thailand
8120-53348120-6809United Kingdom/Hong Kong/Singapore
8121-09738120-6805United States/Canada/Mexico
1
The power cord for the HPE 2530-48G-PoE+-2SFP+Switch supports a higher amperage and uses a C15 connector.
WARNING! Japan Power Cord:
Important Note for the 2530-PoE+ Switches
For PoE/PoE+ information see the HPE Power over Ethernet (PoE/PoE+) Planning and Implementation
Guide on the Hewlett Packard Enterprise website at: http://www.hpe.com/networking/support.
Transceiver Support Notes
• Revision “B” or later SFP transceivers only. This switch requires revision “B” or later SFP
transceiver products — the product number ends with the letter “B” or later (for example, J4858B,
J4859C).
• Use only genuine Hewlett Packard Enterprise transceivers. For a list of HPE SFP or SFP+
transceivers supported by various Hewlett Packard Enterprise switch products, visit http://
www.hpe.com/networking/support:

HP 2530 Specifications

General

Layer	Layer 2
Operating Temperature	32°F to 113°F (0°C to 45°C)
Model	HP 2530
Power over Ethernet (PoE)	PoE+
Management	Web interface, CLI, SNMP
Memory	128 MB flash
Input Voltage	100-240 VAC
Jumbo Frame Support	Yes
Operating Humidity	15% to 95% non-condensing