HP 2530 Quick Setup Guide

See “SFP Installation Notes” (page 3).
7. (Optional) Configure the switch for management.
By factory default, the switch will automatically obtain its IP network configuration from a DHCP or
BootP server. Subsequently, you can determine the IP address assigned to the switch by inspecting
your DHCP/BootP server or by using LLDP from a connected device.
You can also manage and configure the switch through a console port connection. Connect a VT-100
terminal or PC (with suitable terminal emulation software) to the switch using the serial cable (DB-9
and RJ-45 connectors) supplied with the switch.
NOTE: You can also connect a console to the switch through the USB console port (cable
not provided). Use a USB 2.0 high-speed cable with a male type A (4-pin) to male micro-B
(5-pin) connector. Maximum allowable length is 5m. For more information on using the USB
console port, see the Installation and Getting Started Guide for your switch.
For information on configuration and remote management, see the Management and Configuration
Guide for your switch. The manuals are available at http://www.hpe.com/networking/support.
SFP Installation Notes
• Use only genuine Hewlett Packard Enterprise SFPs. Non-Hewlett Packard Enterprise SFP
transceivers are not supported. Use of genuine Hewlett Packard Enterprise products ensures that
your network maintains optimal performance and reliability. Should you require additional transceivers,
contact an Hewlett Packard Enterprise sales representative or an authorized reseller.
• Hot swapping SFP transceivers. Supported SFP transceivers that you can install in your Hewlett
Packard Enterprise switch can be “hot swapped”–removed and installed while the switch is receiving
power. You should disconnect the network cables from the SFP transceivers before hot-swapping
them.
When you replace an SFP transceiver with another of a different type, the switch may retain selected
port-specific configuration settings that were configured for the replaced unit. Be sure to validate or
reconfigure port settings as required.

HP 2530 Specifications

General

Layer	Layer 2
Operating Temperature	32°F to 113°F (0°C to 45°C)
Model	HP 2530
Power over Ethernet (PoE)	PoE+
Management	Web interface, CLI, SNMP
Memory	128 MB flash
Input Voltage	100-240 VAC
Jumbo Frame Support	Yes
Operating Humidity	15% to 95% non-condensing