HP 2600 Series

10-15
Traffic/Security Filters (ProCurve Series 2600/2600-PWR and 2800 Switches)
Using Source-Port Filters
Using the IDX value in the show filter command, we can see how traffic is
filtered on a specific port (Value).The two outputs below show a non-
accounting and an accounting switch port.
ProCurve(config)# show filter 4
Traffic/Security Filters
Filter Type : Source Port
Source Port : 5
Dest Port Type | Action
--------- --------- + -------
1 10/100TX | Forward
2 10/100TX | Drop
3 10/100TX | Drop
4 10/100TX | Drop
5 10/100TX | Drop
6 10/100TX | Drop
7 10/100TX | Drop
8 10/100TX | Drop
9 10/100TX | Drop
10 10/100TX | Drop
11 10/100TX | Drop
12 10/100TX | Drop
. . .
ProCurve(config)# show filter 24
Traffic/Security Filters
Filter Type : Source Port
Source Port : 10
Dest Port Type | Action
--------- --------- + -------
1 10/100TX | Drop
2 10/100TX | Drop
3 10/100TX | Drop
4 10/100TX | Drop
5 10/100TX | Drop
6 10/100TX | Drop
7 10/100TX | Forward
8 10/100TX | Drop
9 10/100TX | Drop
10 10/100TX | Drop
11 10/100TX | Drop
12 10/100TX | Drop
. . .