HP 2600 Series

3-23
Web and MAC Authentication for the Series 2600/2600-PWR and 2800 Switches
Configuring MAC Authentication on the Switch
Configure the Switch for MAC-Based Authentication
Command Page
Configuration Level
aaa port-access mac-based addr-format 3-23
[no] aaa port-access mac-based [e] < port-list >3-23
[addr-limit] 3-24
[addr-moves] 3-24
[auth-vid] 3-24
[logoff-period] 3-24
[max-requests] 3-24
[quiet-period] 3-25
[reauth-period] 3-25
[reauthenticate] 3-25
[server-timeout] 3-25
[unauth-vid] 3-25
Syntax: aaa port-access mac-based addr-format
<no-delimiter|single-dash|multi-dash|multi-colon>
Specifies the MAC address format to be used in the
RADIUS request message. This format must match the
format used to store the MAC addresses in the RADIUS
server. (Default: no-delimiter)
no-delimiter — specifies an aabbccddeeff format.
single-dash — specifies an aabbcc-ddeeff format.
multi-dash — specifies an aa-bb-cc-dd-ee-ff format.
multi-colon — specifies an aa:bb:cc:dd:ee:ff format.
Syntax: [no] aaa port-access mac-based [e] < port-list >
Enables MAC-based authentication on the specified
ports. Use the no form of the command to disable MAC-
based authentication on the specified ports.