7-7
Configuring Secure Socket Layer (SSL)
Configuring the Switch for SSL Operation
Configuring the Switch for SSL
Operation
1. Assign Local Login (Operator) and Enable (Manager)
Password
At a minimum, ProCurve recommends that you always assign at least a
Manager password to the switch. Otherwise, under some circumstances,
anyone with Telnet, web, or serial port access could modify the switch’s
configuration.
SSL-Related CLI Commands in This Section Page
web-management ssl page 7-19
show config page 7-19
show crypto host-cert page 7-12
crypto key
generate cert [rsa] <512 | 768 |1024> page 7-10
zeroize cert page 7-10
crypto host-cert
generate self-signed [arg-list] page 7-10
zeroize page 7-10
To Next Page
Loading...
