3-16
Web and MAC Authentication for the Series 2600/2600-PWR and 2800 Switches
Configuring the Switch To Access a RADIUS Server
For example, to configure the switch to access a RADIUS server at IP address
192.168.32.11 using a server-specific shared secret key of ‘2Pzo22’
Figure 3-4. Example of Configuring a Switch To Access a RADIUS Server
Optional. Specifies an encryption key for use during
authentication (or accounting) sessions with the speci-
fied server. This key must match the encryption key used
on the RADIUS server. Use this command only if the
specified server requires a different encryption key than
configured for the global encryption key, above.
The no form of the command removes the key configured
for a specific server.
ProCurve(config)# radius-server host 192.168.32.11 key 2Pzo22
ProCurve(config)# show radius
Status and Counters - General RADIUS Information
Deadtime(min) : 0
Timeout(secs) : 5
Retransmit Attempts : 3
Global Encryption Key :
Auth Acct
Server IP Addr Port Port Encryption Key
--------------- ----- ----- --------------------------------
192.168.32.11 1812 1813 2Pzo22
ProCurve(config)#
To Next Page
Loading...
Need help?
General