HP 2920 Series User Manual

Example 29 General RIP information listing
HP Switch(config)# show ip rip
RIP global parameters
RIP protocol : enabled
Auto-summary : enabled
Default Metric : 1
Distance : 120
Route changes : 0
Queries : 0
RIP interface information
IP Address Status Send mode Recv mode Metric Auth
----------- -------- --------- ---------- ------- ----
100.1.0.1 enabled V2-only V2-only 5 none
100.2.0.1 enabled V2-only V2-only 5 none
100.3.0.1 enabled V2-only V2-only 5 none
100.4.0.1 enabled V2-only V2-only 5 none
100.10.0.1 enabled V2-only V2-only 5 none
100.11.0.1 enabled V2-only V2-only 5 none
RIP peer information
IP Address Bad routes Last update timeticks
--------------- ----------- ---------------------
The display is a summary of global RIP information, information about interfaces with RIP enabled,
and information about RIP peers. The following fields are displayed:
Status of the RIP protocol on the router. RIP must be enabled here and on the
VLAN interface for RIP to be active.
RIP protocol
The default is disabled.
Status of auto-summary for all interfaces running RIP. If auto-summary is
enabled, subnets will be summarized to a class network when advertising
outside of the given network.
Auto-summary
Sets the default metric for imported routes. This is the metric that will be
advertised with the imported route to other RIP peers. A RIP metric is a
Default metric
measurement used to determine the "best" path to network: 1 is the best, 15
is the worst, 16 is unreachable.
The number of times RIP has modified the routing switch’s routing table.Route changes
The number of RIP queries that have been received by the routing switch.Queries
RIP information on the VLAN interfaces on which RIP is enabled:RIP interface information
IP address IP address of the VLAN interface running RIP.
Status Status of RIP on the VLAN interface.
Send mode Format of the RIP updates: RIP 1, RIP 2, or RIP 2 version 1
compatible.
Recv mode The switch can process RIP 1, RIP 2, or RIP 2 version 1
compatible update messages.
Metric Path "cost", a measurement used to determine the "best" RIP
route path: 1 is the best, 15 is the worst, 16 is unreachable.
Auth RIP messages can be required to include an authentication
key if enabled on the interface.
RIP peers are neighboring routers from which the routing switch has received
RIP updates:
RIP peer information
Configuring RIP 57

HP 2920 Series Specifications

General

Brand	HP
Model	2920 Series
Category	Switch
Language	English