Need help?Do you have a question about the HP 2920 and is the answer not in the manual?
General| Layer | Layer 3 |
|---|---|
| Power Device | Internal power supply |
| Ports | 24 or 48 x 10/100/1000 ports |
| Stacking | Yes, up to 4 units |
| Management | Web, CLI, SNMP |
| Jumbo Frame Support | Yes |
| Routing Protocol | Static, RIP, OSPF |
| VLANs | 4094 |
| Power Supply | 100-240V AC, 50/60Hz |
| Operating Temperature | 0°C to 45°C (32°F to 113°F) |
| Power over Ethernet (PoE) | Available on some models (PoE+) |
Step-by-step guide for installing the HP 2920 switch.
Essential safety and preparation guidelines before installing the switch.
Steps for basic switch configuration for initial setup and management.
Common issues and initial steps for troubleshooting switch problems.
Using switch LED patterns to diagnose and identify problems.
Methods for testing switch hardware functionality through resets and checks.
To Next Page