●
Card reader board (See Card reader board on page 48)
●
Power button board (See Power button board on page 49)
Remove the top cover:
1. Close the computer.
2. Turn the computer upside down with the front toward you.
3. Remove the two rubber feet (1).
NOTE: The rubber feet are included in the Rubber Kit, spare part number 746669-001.
4. Remove the ten Phillips PM2.5×6.5 screws (2) that secure the top cover to the base enclosure.
5. Remove the two Phillips PM2.0×2.0 broad head screws (1) in the optical drive bay that secure the top
cover to the base enclosure.
Component replacement procedures 43
To Next Page
Loading...
