To Next Page

To Previous Page

5-16

TACACS+ Authentication

Configuring TACACS+ on the Switch

For example, here is a set of access options and the corresponding commands

to configure them:

Console Login (Operator or Read-Only) Access: Primary using TACACS+ server.

Secondary using Local.

HP Switch(config)# aaa authentication console login tacacs local

Console Enable (Manager or Read/Write) Access: Primary using TACACS+ server.

Secondary using Local.

HP Switch(config)# aaa authentication console enable tacacs local

Telnet Login (Operator or Read-Only) Access: Primary using TACACS+ server.

Secondary using Local.

HP Switch(config)# aaa authentication Telnet login tacacs local

Telnet Enable (Manager or Read/Write Access: Primary using TACACS+ server.

Secondary using Local.

HP Switch(config)# aaa authentication telnet enable tacacs local

Deny Access and Close the Session After Failure of Two Consecutive Username/Password Pairs:

HP Switch(config)# aaa authentication num-attempts 2

Other manuals for HP 3500yl Series

Questions and Answers:

Need help?

Do you have a question about the HP 3500yl Series and is the answer not in the manual?

General