To Next Page

To Previous Page

6-63

RADIUS Authentication, Authorization, and Accounting

Accounting Services

Note Configuring interim-update for Command accounting results in all commands

being reported as “update” records, regardless of whether common or unique

is configured for the accounting session ID (page 6-60).

Example. To configure RADIUS accounting on the switch with start-stop for

Exec functions, stop-only for system functions, and interim-update for com-

mands functions. This example continues from figure 6-21, where the session

ID was configured as common.

Syntax: [no] aaa accounting < exec | network | system > < start-stop | stop-only >

radius

[no] aaa accounting command < stop-only | interim-only > radius

Configures RADIUS accounting service type and how data will be

sent to the RADIUS server.

< exec | network | system | command >: Specifies an accounting

service type to configure. Refer to “Accounting Service

Types” on page 6-61.

start-stop: Applies to exec, network, and system

accounting service types. Refer to “Accounting

Controls” on page 6-62.

stop-only: Applies to all accounting service types.

Refer to “Accounting Controls” on page 6-62.

interim-update:

Applies to the commands accounting

service type. Refer to “Accounting Controls” on page

6-62.

Other manuals for HP 3500yl Series

Questions and Answers:

Need help?

Do you have a question about the HP 3500yl Series and is the answer not in the manual?

General