HP 3500yl Series User Manual

10-96
IPv4 Access Control Lists (ACLs)
Editing an Existing ACL
Figure 10-31. Example of Overwriting One Remark with Another
HP Switch(config)# ip access-list standard Accounting
HP Switch(config-std-nacl)# permit host 10.10.10.115
HP Switch(config-std-nacl)# deny 10.10.10.1/24
HP Switch(config-std-nacl)# remark Marketing
HP Switch(config-std-nacl)# remark Channel_Mktg
HP Switch(config-std-nacl)# show run
.
.
.
ip access-list standard "Accounting"
10 permit 10.10.10.115 0.0.0.0
20 deny 10.10.10.1 0.0.0.255
30 remark "Channel_Mktg"
exit
Where multiple remarks are
sequentially entered for
automatic inclusion at the end of
an ACL, each successive remark
replaces the previous one until an
ACE is configured for automatic
inclusion at the end of the list.

HP 3500yl Series Specifications

General

Input Voltage	100-240 VAC
Ports	24/48 x 10/100/1000 ports (depending on model)
Uplink Ports	4 x SFP ports
Layer	Layer 3
Management	CLI, Web, SNMP
Routing Protocol	RIP, OSPF, BGP
Operating Temperature	0°C to 45°C
Stacking	Yes
Memory	512 MB
VLAN Support	Yes
Layer 3 Routing	Yes
Security Features	ACLs, 802.1X
Power Supply	Internal
Power over Ethernet (PoE)	Optional