To Next Page

To Previous Page

13-62

Configuring Port-Based and User-Based Access Control (802.1X)

Displaying 802.1X Configuration, Statistics, and Counters

Figure 13-16. Example of show port-access authenticator clients Command Output

Syntax: show port-access authenticator clients [port-list]

Displays the session status, name, and address for each

802.1X port-access-authenticated client on the switch.

Multiple authenticated clients may be displayed for the same

port. The IP address displayed is taken from the DHCP

binding table (learned through the DHCP Snooping feature).

• If DHCP snooping is not enabled on the switch, n/a (not

available) is displayed for a client’s IP address.

• If an 802.1X-authenticated client uses an IPv6 address,

n/a - IPv6 is displayed.

• If DHCP snooping is enabled but no MAC-to-IP address

binding for a client is found in the DHCP binding table,

n/a - no info is displayed.

HP Switch(config)# show port-access authenticator clients

Port Access Authenticator Client Status

Port Client Name MAC Address IP Address Session Status

----- ------------ ------------- --------------- --------------

1 webuser1 001321-eb8063 192.192.192.192 Authenticated

1 webuser2 001560-b3ea48 n/a - no info Authenticating

1 webuser3 000000-111111 n/a - IPv6 Authenticating

3 webuser4 000000-111112 n/a Authenticating

Other manuals for HP 3500yl Series

Questions and Answers:

Need help?

Do you have a question about the HP 3500yl Series and is the answer not in the manual?

General