Programming 15-13
You only need to run this program once to configure your
aplet’s VIEWS menu. Once the aplet’s VIEWS menu is
configured, it remains that way until you run SETVIEWS
again.
You do not need to include this program for your aplet to
work, but it is useful to specify that the program is
attached to the aplet, and transmitted when the aplet is
transmitted.
7. Return to the program
catalog. The programs
that you created should
appear as follows:
8. You must now RUN the
program EXP.SV to
execute the SETVIEWS command and create the
modified VIEWS menu. Check that the name of the new
aplet is highlighted in the APLET view.
9. You can now return to the APLET library and press
START to run your new aplet.
To Next Page
Loading...
