Getting started 1-17
Displays pictures to
supplement an aplet.
See “Notes and sketches” on
page 14-1 for further
information.
Aplet view configuration
You use the SETUP keys (>6+,)7@>3/27@,and >6+,)7@>180@) to
configure the aplet. For example, press >6+,)7@
SETUP-PLOT
(>6+,)7@>3/27@)to display the input form for setting the aplet’s
plot settings. Angle measure is controlled using the
MODES
view.
Plot Setup Press>6+,)7@SETUP-PLOT. Sets
parameters to plot a graph.
Numeric Setup Press >6+,)7@SETUP-NUM. Sets
parameters for building a table
of numeric values.
Symbolic
Setup
This view is only available in
the Statistics aplet in 2VAR
mode, where it plays an
important role in choosing data
models. Press (>6+,)7@
SETUP
SYMB.
To change views Each view is a separate environment. To change a view, select
a different view by pressing >6<0%@, >180@, >3/27@ keys or
select a view from the VIEWS menu. To change to HOME,
press >+20(@. You do not explicitly close the current view,
you just enter another one—like passing from one room into
another in a house. Data that you enter is automatically saved
as you enter it.
To save aplet
configuration
You can save an aplet configuration that you have used, and
transfer the aplet to other HP 39G/40G calculators. See
“Sending and receiving aplets” on page 16-5.
To Next Page
Loading...
Need help?
General
