Store the file in a local directory.
4. Open and log in to HP P6000 Command View.
5. In the navigation pane, select the array whose disk drive firmware you want to update.
The Initialized Storage System Properties window opens.
6. Select the System Options tab.
The System Options window opens.
Figure 27 System Options — Code load system
7. Click Code load system.
The Code Load Selection window opens (Figure 28 (page 59)).
Figure 28 Code Load Selection window – disk drives
Choose Code Load Disk Drives On Line and click Select to proceed or Cancel to exit the
procedure. A warning Confirm Disk Drive Code Load confirmation window opens
Figure 29 (page 60).
Step 6. Upgrading the disk drive firmware 59
To Next Page
Loading...
