Need help?Do you have a question about the HP MR Gen10 Plus and is the answer not in the manual?
General| Device Type | RAID Controller |
|---|---|
| Interface | PCIe 3.0 x8 |
| RAID Support | Yes |
| Category | Controller |
| RAID Levels | 0, 1, 5, 6, 10, 50, 60 |
| Memory | 2GB Flash-backed cache |
| Storage | SAS/SATA |
| Power Supply | Not Applicable |
Overview of the 200 series MR216i-a and MR216i-p controllers for virtualized environments.
Overview of the 400 series MR416i-a and MR416i-p controllers for data center environments.
Lists the features supported by the controller, covering environments, RAID, transformation, drive tech, security, reliability, performance.
Details advanced RAID configuration options, including RAID 5, 50, 6, and 60, with their characteristics.
Provides step-by-step instructions for installing the controller into an existing server.
Guides through the process of installing the controller in a new, unconfigured server.
Details how to install the OS and controller driver after hardware installation.
Explains how to set up boot controller options, varying between UEFI and Legacy modes.
Explains how to configure arrays and controllers using UEFI, MR Storage Administrator, or StorCLI.
Overview of the MR Storage Administrator application for managing HPE MR Gen10 Plus Controllers.
Description of the StorCLI command-line interface for managing the HPE MR Gen10 Plus Controller.
Details the capabilities of the embedded UEFI System Utilities for configuration tasks.
Step-by-step guide to creating a logical drive, including RAID levels, strip size, and policies.
Procedure to enable drive security using Local or External Key Management modes.
Details on configuring various advanced controller properties like boot mode, drive security, and SMART polling.
Instructions for updating server and controller firmware using the Service Pack for ProLiant (SPP).
Details diagnostic tools like MR Storage Administrator and System Event Log for array troubleshooting.
Diagrams and descriptions of components for MR216i-p, MR416i-p, MR416i-a, and MR216i-a controllers.
Overview of backup power source options (battery, capacitor) for controller cache.
Explains binary and SI prefixes used for memory and storage capacity measurements.
Defines the naming conventions used for different RAID levels by Hewlett Packard Enterprise.
Information on accessing support, documentation, and other resources for HPE products.
Details on how to contact HPE support and the information required for assistance.
Information on downloading software updates and subscribing to alerts from HPE.
To Next Page
