HP MR Gen10 Plus User Manual

Making a JBODMaking a JBOD
WARNING: WARNING: Converting a drive to JBOD will permanently delete any data on the drive.
You can perform this task using either the Configuration Management screen or the Drive Management screen.
ProcedureProcedure
From the System Utilities screen, navigate to the Make JBOD menu option using either of the following steps:
1. Select System Configuration > HPE MRXXX Gen10+ > Main Menu > Configuration Management > Make JBOD.
2. In the Make JBOD screen, select the Unconfigured Good drive that you want to convert to JBOD.
3. Click OK.
4. Review and address any warning messages, as needed.
5. Click Confirm and Yes to proceed.
The Success screen appears to confirm that the operation completed successfully. For the drive status change to reflect on the
Drive Management screen, refresh the view.
1. Select System Configuration > HPE MRXXX Gen10+ > Main Menu > Drive Management.
2. In the Drive Management screen, select the Unconfigured Good drive that you want to convert to JBOD.
3. In the drive screen, select Make JBOD from the Operation drop-down menu.
4. Click Go.
The Success screen appears to confirm that the operation completed successfully. For the drive status change to reflect on the
Drive Management screen, refresh the view.
Making a JBOD 114

HP MR Gen10 Plus Specifications

General

Device Type	RAID Controller
Interface	PCIe 3.0 x8
RAID Support	Yes
Category	Controller
RAID Levels	0, 1, 5, 6, 10, 50, 60
Memory	2GB Flash-backed cache
Storage	SAS/SATA
Power Supply	Not Applicable