HP MR Gen10 Plus User Manual

Selecting a boot modeSelecting a boot mode
ProcedureProcedure
1. From the System Utilities screen, select System ConfigurationSystem Configuration > Boot OptionsBoot Options > Boot ModeBoot Mode, and press the EnterEnter key.
2. Select a setting and press the EnterEnter key.
UEFI Mode (default) - Configures the system to boot to a UEFI-compatible operating system.
NOTE:NOTE:
When booting to the UEFI Mode, configure the system to use native UEFI graphic drivers.
Legacy BIOS Mode - Configures the system to boot to a traditional operating system in Legacy BIOS compatibility mode.
3. Press the F10F10 key to save your selection.
4. Reboot the server.
Selecting a boot mode 93

HP MR Gen10 Plus Specifications

General

Device Type	RAID Controller
Interface	PCIe 3.0 x8
RAID Support	Yes
Category	Controller
RAID Levels	0, 1, 5, 6, 10, 50, 60
Memory	2GB Flash-backed cache
Storage	SAS/SATA
Power Supply	Not Applicable