HP MR Gen10 Plus User Manual

Selecting RAID for usable capacitySelecting RAID for usable capacity
If your environment requires a high usable capacity, select a RAID type that is optimized for usable capacity. The chart in this section
demonstrates the relationship between the number of drives in the array and the percent usable capacity over the capacity for RAID 0.
Consider the following points when selecting the RAID type:
Usable capacity decreases as fault tolerance improves due to an increase in parity data.
The usable capacity for RAID 10 remains flat with larger arrays.
The usable capacity for RAID 5, 50, 6, and 60 increases with larger arrays.
RAID 50 and RAID 60 assumes two parity groups.
Note the minimum drive requirements for the RAID types, as shown in the table below.
RAID typeRAID type Minimum number of drivesMinimum number of drives
RAID 0 1
RAID 10 2
RAID 5 3
RAID 6 4
RAID 50 6
RAID 60 8
Supported RAID levels may vary based on the controller model.
Selecting RAID for usable capacity 23

HP MR Gen10 Plus Specifications

General

Device Type	RAID Controller
Interface	PCIe 3.0 x8
RAID Support	Yes
Category	Controller
RAID Levels	0, 1, 5, 6, 10, 50, 60
Memory	2GB Flash-backed cache
Storage	SAS/SATA
Power Supply	Not Applicable