HP MR Gen10 Plus User Manual

Full initializationFull initialization
During full initialization, a complete initialization is done on the new configuration. You cannot write data to the new logical drive until
the initialization is complete. This process can take a long time if the drives are large. This initialization overwrites all blocks and
destroys all data on the logical drive.
Monitor the progress of the initialization process using the progress indicator.
Full initialization 40

HP MR Gen10 Plus Specifications

General

Device Type	RAID Controller
Interface	PCIe 3.0 x8
RAID Support	Yes
Category	Controller
RAID Levels	0, 1, 5, 6, 10, 50, 60
Memory	2GB Flash-backed cache
Storage	SAS/SATA
Power Supply	Not Applicable