Configuring Spare settingsConfiguring Spare settings
ProcedureProcedure
1. From the System Utilities screen, select System Configuration > HPE MRXXX Gen10+ > Main Menu > Controller Management.
2. In the Controller Management screen, select Advanced Controller Properties .
3. In the Advanced Controller Properties screen, click Spare to configure the Spare settings.
4. In the Spare screen, enable or disable the following settings:
Persistent Spare - The option to have the system backplane or the storage enclosure drive slots dedicated as spare slots. If
enabled, the replacement of a spare drive in the same slot will automatically configure the drive as a spare.
Replace Drive - The option to copy data from a spare drive to a drive.
Replace Drive on SMART Error - The option to start a Replace operation if a SMART error is detected on a drive.
5. Click Apply Changes.
To Next Page
Loading...
