HP MR Gen10 Plus - Configuring Advanced Controller Properties

Configuring advanced controller propertiesConfiguring advanced controller properties
ProcedureProcedure
1. From the System Utilities screen, select System Configuration > HPE MRXXX Gen10+ > Main Menu > Controller Management.
2. In the Controller Management screen, select Advanced Controller Properties .
3. In the Advanced Controller Properties screen, click Cache and Memory to configure the cache and memory settings.
For more information, see Configuring cache and memory settings .
4. Click Patrol Read to configure the Patrol Read settings.
For more information, see Configuring Patrol Read settings .
5. Click Spare to configure the Spare settings.
For more information, see Configuring Patrol Read settings .
6. Click Task Rates to configure the Task Rates settings.
For more information, see Configuring Patrol Read settings .
7. Modify any of the following controller properties:
Property Description
Auto Import
Foreign
Configuration
Enables or disables the automatic import of foreign configureations without any user intervention
Coercion Mode Drive coercion forces the drives of varying capacities to the same size so they can be used in an array. The
coercion mode options are None, 128 MB, and 1 GB.
Boot Mode Specifies options to handle errors (if they occur) during boot time. Possible options are:
Stop on error - shows errors and waits for your input
Pause on error - non-critical errors show up briefly, giving you a choice to take action before the firmware
proceeds with the boot. Critical errors wait for your response and do not proceed with the boot.
Ignore errors - errors are ignored and the firmware proceeds with the boot.
Safe mode on errors - the application loads but with a limited set of operations. You cannot use this
adapter as a boot adapter while in safe mode.
Controller BIOS Enables or disables the controller BIOS. If the boot device is on the selected RAID controller, the BIOS should
be enabled.
ROC
Temperature (C)
Temperature of the ROC. (read only)
Shield State
Supported
Whether shield state is supported in the controller or not.
Drive Security Status of the drive security (encryption) feature on the controller.
T10-PI Status of the data protection feature on the controller.
Extended Logical
Drive Support
Allows you to enable or disable the controller's max logical drive limit. Any change takes effect after the
system reboots.
Maintain Drive
Fail History
Enables you to track the bad drives.
SMART Polling Determines how frequently the controller polls for drives reporting a Predictive Drive Failure. The default is
300 seconds.
Stop Consistency
Check on Error
Enables or disables the option to stop the consistency check operation on a redundant logical drive if there is
an inconsistency found in the data.
JBOD Mode Enables or disables the JBOD mode.
Configuring advanced controller properties 131