HP MR Gen10 Plus User Manual

Selecting RAID for fault toleranceSelecting RAID for fault tolerance
If your IT environment requires a high level of fault tolerance, select a RAID level that is optimized for fault tolerance.
This chart shows the relationship between the RAID level fault tolerance and the size of the storage array. The chart includes RAID 0, 5,
50, 10, 6, and 60. It also shows the percent reliability in increments between 1 and one billion and the storage array drive increments
between 0 and 96.
This chart assumes that two parity groups are used for RAID 50 and RAID 60.
This chart shows that:
RAID 10 is 30,000 times more reliable than RAID 0.
The fault tolerance of RAID 5, 50, 6, and 60 decreases as the array size increases.
Selecting RAID for fault tolerance 21

HP MR Gen10 Plus Specifications

General

Device Type	RAID Controller
Interface	PCIe 3.0 x8
RAID Support	Yes
Category	Controller
RAID Levels	0, 1, 5, 6, 10, 50, 60
Memory	2GB Flash-backed cache
Storage	SAS/SATA
Power Supply	Not Applicable