Load paper to the 3 x 500-sheet paper feeder
Introduction
The following information describes how to load paper in any of the trays in the 3 x 500-sheet paper feeder.
Each tray holds up to 500 sheets of 75 g/m2 (20 lb) paper.
CAUTION: Do not extend more than one paper tray at a time.
1. Open the tray.
NOTE: Do not open this tray while it is in use.
2. Before loading paper, adjust the paper-width
guides by squeezing the adjustment latches and
sliding the guides to the size of the paper being
used. The edge of the tray guide should line up
exactly with the marking on the tray.
3. Adjust the paper-length guide by squeezing the
adjustment latch and sliding the guide to the size
of the paper being used.
ENWW Load paper to the 3 x 500-sheet paper feeder 31
To Next Page
Loading...