15
…
6 -rw- 898180 Jun 26 2013 09:23:51 diag.tar.gz
1021808 KB total (259072 KB free)
# To display operating statistics on the monitor terminal, enter n at the prompt.
Save or display diagnostic information (Y=save, N=display)? [Y/N] :n
……
Failures at startup
No display on the configuration terminal
Symptom
The configuration terminal does not have display when the blade switch is powered on.
Solution
To resolve the problem:
1. Verify that the blade switch is operating correctly.
2. Verify that the console port is connected to the correct serial port on the terminal.
3. Verify that the console cable is in good quality and is operating correctly.
4. If you use a converter to connect the terminal, a laptop, for example, and the console cable, make
sure the driver for the converter is installed.
5. Verify that the configuration terminal and the console port of the switch have the same settings. The
default setting for the console port are as follows:
{ Baud rate—9600.
{ Data bits—8.
{ Parity—None.
{ Stop bits—1.
{ Flow control—None.
{ Emulation—VT100.
If the console port settings change, change the terminal settings accordingly.
6. If the problem persists, contract HP Support.
Garbled display on the configuration terminal
Symptom
The configuration terminal displays garbled text when the blade switch is powered on.
Solution
To resolve the problem:
1. Verify that the configuration terminal and the console port of the switch have the same settings. The
default setting for the console port are as follows:
{ Baud rate—9600.
To Next Page
Loading...
