HP 6125XLG - Software Upgrade Failure; Hardware Failures

17
6. Log in to the new device. Configure IRF member ID and IRF port bindings on the new device based
on the recorded IRF configuration information of the failed device.
7. Install the modules and cables for the new device.
8. Activate the IRF port configuration on the new device. The device reboots automatically and joins
the IRF.
9. Verify that the new device is operating correctly by viewing the operating state of the new device
from the OA module in the enclosure.
The new device automatically gets global and interface configuration of the failed device from the
IRF and performs the same network functions as the failed device.
10. If the problem persists, contact HP Support.
Software upgrade failure
Symptom
Software upgrade fails.
Solution
To resolve the problem:
1. Verify that the physical ports are connected correctly.
2. If you log in to the blade switch from the console port, verify that terminal parameters are set
correctly.
3. Verify that the information on the HyperTerminal is input correctly.
{ If software is downloaded using XMODEM, verify that the baud rate set on the HyperTerminal
and the console port is the same.
{ If software is upgraded using TFTP, verify that the IP address, the file name, and the assigned
working directory of the TFTP server are correct.
{ If software is upgraded using FTP, verify that the IP address, the file name and the assigned
working directory of the FTP server, FTP username and password are correct.
4. Verify that the FTP server or the TFTP server is operating correctly and the configuration is correct.
5. Verify that the flash has enough space to save the file to be downloaded.
6. Verify that the file for upgrade is suitable for the product and the file type is correct.
7. Verify that the system software image file and the BootWare file versions are correct. For the
software version matrix, see relevant Release Notes.
8. If the problem persists, contact HP Support.
Hardware failures
Symptom
The Health LED is not green.
Solution
To resolve the problem:
1. Verify that the enclosure is operating correctly.