HP 6125XLG - Load Sharing Configuration Example; Network Requirements; Configuration Procedure

To Next Page

To Previous Page

113

Load sharing configuration example

Network requirements

As shown in Figure 50, Switch A has two equal-cost routes to Switch B. Configure load sharing to forward

packets through Switch B to the destination IP address 1.2.3.4/24.

Figure 50 Network diagram

Configuration procedure

# On Switch A, assign Ten-GigabitEthernet 1/1/9 to VLAN 10, and Ten-GigabitEthernet 1/1/10 to

VLAN 20.

<SwitchA> system-view

[SwitchA] vlan 10

[SwitchA-vlan10] port Ten-GigabitEthernet 1/1/9

[SwitchA-vlan10] quit

[SwitchA] vlan 20

[SwitchA-vlan20] port Ten-GigabitEthernet 1/1/10

[SwitchA-vlan20] quit

# On Switch A, configure IP addresses for VLAN-interface 10 and VLAN-interface 20.

[SwitchA] interface vlan-interface 10

[SwitchA-Vlan-interface10] ip address 10.1.1.1 24

[SwitchA-Vlan-interface10] quit

[SwitchA] interface vlan-interface 20

[SwitchA-Vlan-interface20] ip address 20.1.1.1 24

[SwitchA-Vlan-interface20] quit

# On Switch B, assign Ten-GigabitEthernet 1/1/9 to VLAN 10, and Ten-GigabitEthernet 1/1/10 to

VLAN 20.

<SwitchB> system-view

[SwitchB] vlan 10

[SwitchB-vlan10] port Ten-GigabitEthernet 1/1/9

[SwitchB-vlan10] quit

[SwitchB] vlan 20

[SwitchB-vlan20] port Ten-GigabitEthernet 1/1/10

[SwitchB-vlan20] quit

# On Switch B, configure IP addresses for VLAN-interface 10 and VLAN-interface 20.

[SwitchB] interface vlan-interface 10

[SwitchB-Vlan-interface10] ip address 10.1.1.2 24

[SwitchB-Vlan-interface10] quit

[SwitchB] interface vlan-interface 20

Other manuals for HP 6125XLG